Photo: Shannen B

What is the weakest earthquake wave?

The strongest deep-focus earthquake in seismic record was the magnitude 8.3 Okhotsk Sea earthquake that occurred at a depth of 609 km in 2013. The deepest earthquake ever recorded was a small 4.2 earthquake in Vanuatu at a depth of 735.8 km in 2004.

en.wikipedia.org - Deep-focus earthquake - Wikipedia

Can you use the toilet in a power cut?

Your toilet does not require any electricity to operate. It can run even if the power is off. With that in mind, a toilet does require water to...

Last updated Dec 6, 2020

How long does it take for solar panels to pay for themselves?

six to ten years The most common estimate of the average payback period for solar panels is six to ten years. This is a pretty wide range because...

Last updated Apr 9, 2020

Promotion

A deep-focus earthquake in seismology (also called a plutonic earthquake) is an earthquake with a hypocenter depth exceeding 300 km. They occur almost exclusively at convergent boundaries in association with subducted oceanic lithosphere. They occur along a dipping tabular zone beneath the subduction zone known as the Wadati–Benioff zone.[1]

Discovery [ edit ]

Preliminary evidence for the existence of deep-focus earthquakes was first brought to the attention of the scientific community in 1922 by Herbert Hall Turner.[2] In 1928, Kiyoo Wadati proved the existence of earthquakes occurring well beneath the lithosphere, dispelling the notion that earthquakes occur only with shallow focal depths.[3]

Seismic characteristics [ edit ]

Deep-focus earthquakes give rise to minimal surface waves.[3] Their focal depth causes the earthquakes to be less likely to produce seismic wave motion with energy concentrated at the surface. The path of deep-focus earthquake seismic waves from focus to recording station goes through the heterogeneous upper mantle and highly variable crust only once.[3] Therefore, the body waves undergo less attenuation and reverberation than seismic waves from shallow earthquakes, resulting in sharp body wave peaks.

Focal mechanisms [ edit ]

The pattern of energy radiation of an earthquake is represented by the moment tensor solution, which is graphically represented by beachball diagrams. An explosive or implosive mechanism produces an isotropic seismic source. Slip on a planar fault surface results in what is known as a double-couple source. Uniform outward motion in a single plane due to normal shortening gives rise is known as a compensated linear vector dipole source.[3] Deep-focus earthquakes have been shown to contain a combination of these sources. The focal mechanisms of deep earthquakes depend on their positions in subducting tectonic plates. At depths greater than 400 km, down-dip compression dominates, while at depths of 250-300 km (also corresponding to a minimum in earthquake numbers vs. depth), the stress regime is more ambiguous but closer to down-dip tension.[4][5]

Physical process [ edit ]

Shallow-focus earthquakes are the result of the sudden release of strain energy built up over time in rock by brittle fracture and frictional slip over planar surfaces.[6] However, the physical mechanism of deep focus earthquakes is poorly understood. Subducted lithosphere subject to the pressure and temperature regime at depths greater than 300 km should not exhibit brittle behavior, but should rather respond to stress by plastic deformation.[3] Several physical mechanisms have been proposed for the nucleation and propagation of deep-focus earthquakes; however, the exact process remains an outstanding problem in the field of deep earth seismology. The following four subsections outline proposals which could explain the physical mechanism allowing deep focus earthquakes to occur. With the exception of solid-solid phase transitions, the proposed theories for the focal mechanism of deep earthquakes hold equal footing in current scientific literature.

Solid-solid phase transitions [ edit ]

The earliest proposed mechanism for the generation of deep-focus earthquakes is an implosion due to a phase transition of material to a higher density, lower volume phase.[3] The olivine-spinel phase transition is thought to occur at a depth of 410 km in the interior of the earth. This hypothesis proposes that metastable olivine in oceanic lithosphere subducted to depths greater than 410 km undergoes a sudden phase transition to spinel structure. The increase in density due to the reaction would cause an implosion giving rise to the earthquake. This mechanism has been largely discredited due to the lack of a significant isotropic signature in the moment tensor solution of deep-focus earthquakes.[1]

Dehydration embrittlement [ edit ]

Dehydration reactions of mineral phases with high weight percent water would increase the pore pressure in a subducted oceanic lithosphere slab. This effect reduces the effective normal stress in the slab and allow slip to occur on pre-existing fault planes at significantly greater depths that would normally be possible.[1] Several workers[who?] suggest that this mechanism does not play a significant role in seismic activity beyond 350 km depth due to the fact that most dehydration reactions will have reached completion by a pressure corresponding to 150 to 300 km depth (5-10 GPa).[1]

How many pairs of clothes should I bring on trip?

Do the clothing countdown: If you need a mantra to help streamline your wardrobe, use the 5, 4, 3, 2, 1 rule for a weeklong trip: Limit yourself to...

Last updated Mar 1, 2022

Where do snipers usually aim?

chest “So, as a sniper, the reality is you generally have that one chance to put that target down before he skirts away.” Sniper instructors teach...

Last updated Jul 20, 2018

Promotion

Transformational faulting or anticrack faulting [ edit ]

Transformational faulting, also known as anticrack faulting, is the result of the phase transition of a mineral to a higher density phase occurring in response to shear stress in a fine-grained shear zone. The transformation occurs along the plane of maximal shear stress. Rapid shearing can then occur along these planes of weakness, giving rise to an earthquake in a mechanism similar to a shallow-focus earthquake. Metastable olivine subducted past the olivine-wadsleyite transition at 320--410 km depth (depending on temperature) is a potential candidate for such instabilities.[3] Arguments against this hypothesis include the requirements that the faulting region should be very cold, and contain very little mineral-bound hydroxyl. Higher temperatures or higher hydroxyl contents preclude the metastable preservation of olivine to the depths of the deepest earthquakes.

Shear instability / thermal runaway [ edit ]

A shear instability arises when heat is produced by plastic deformation faster than it can be conducted away. The result is thermal runaway, a positive feedback loop of heating, material weakening and strain-localisation within the shear zone.[3] Continued weakening may result in partial melting along zones of maximal shear stress. Plastic shear instabilities leading to earthquakes have not been documented in nature, nor have they been observed in natural materials in the laboratory. Their relevance to deep earthquakes therefore lies in mathematical models which use simplified material properties and rheologies to simulate natural conditions.

Deep focus earthquake zones [ edit ]

Major zones [ edit ]

Eastern Asia/Western Pacific [ edit ]

On the border of the Pacific Plate and the Okhotsk and Philippine Sea Plates is one of the most active deep focus earthquake regions in the world, creating many large earthquakes including the M w 8.3 2013 Okhotsk Sea earthquake. As with many places, earthquakes in this region are caused by internal stresses on the subducted Pacific Plate as it is pushed deeper into the mantle.

Philippines [ edit ]

A subduction zone makes up most of the border of Philippines Sea Plate and Sunda Plate, the fault being partially responsible for the uplift of the Philippines. The deepest sections of the Philippines Sea Plate cause earthquakes as deep as 675 kilometres (419 mi) below the surface.[7] Notable deep-focus earthquakes in this region include a M w 7.7 earthquake in 1972 and the M w 7.6, 7.5, and 7.3 2010 Mindanao earthquakes.

Indonesia [ edit ]

The Australian Plate subducts under the Sunda Plate, creating uplift over much of southern Indonesia, as well as earthquakes at depths of up to 675 kilometres (419 mi).[8] Notable deep-focus earthquakes in this region include a M w 7.9 earthquake in 1996, and a M w 7.5 earthquake in 2007.

Papua New Guinea/Fiji/New Zealand [ edit ]

By far the most active deep focus faulting zone in the world is that caused by the Pacific Plate subducting under the Australian Plate, Tonga Plate, and Kermadec Plate. Earthquakes have been recorded at depths of over 735 kilometres (457 mi),[9] the deepest in the planet. The large area of subduction results in a broad swath of deep-focus earthquakes centered from Papua New Guinea to Fiji to New Zealand, although the angle of the plates' collision causes the area between Fiji and New Zealand to be the most active, with earthquakes of M w 4.0 or above occurring on an almost daily basis.[10] Notable deep-focus earthquakes in this region include a M w 8.2 and 7.9 earthquake in 2018, and a M w 7.8 earthquake in 1919.

Andes [ edit ]

How long does it take for a glass of water to go through the body?

Takeaway. After you drink water, it doesn't take long at all for your body to absorb it. Unlike foods, water can be “digested” in as little as 5...

Last updated Apr 5, 2018

Is PlayStation shutting down PS4?

Sony is shutting down a PS4 exclusive next year, making the PlayStation game unplayable in the process. The good news within this bad news is that...

Last updated Oct 24, 2018

Promotion

The subduction of the Nazca Plate under the South American Plate, in addition to creating the Andes mountain range, has also created a number of deep faults under the surfaces of Colombia, Peru, Brazil, Bolivia, Argentina, and even as far east as Paraguay.[11] Earthquakes frequently occur in the region at depths of up to 670 kilometres (420 mi) beneath the surface.[12] Several large earthquakes have taken place here, including the M w 8.2 1994 Bolivia earthquake (631 km deep), the M w 8.0 1970 Colombia earthquake (645 km deep), and M w 7.9 1922 Peru earthquake (475 km deep).

Minor zones [ edit ]

Granada, Spain [ edit ]

Roughly 600–630 kilometres (370–390 mi) under the city Granada in southern Spain, several large earthquakes have been recorded in modern history, notably including a M w 7.8 earthquake in 1954,[13] and a M w 6.3 earthquake in 2010. As Spain isn't near to any known subduction zones, the exact cause for the continual earthquakes remains unknown.[14]

Tyrrhenian Sea [ edit ]

The Tyrrhenian Sea west of Italy is host to a large number of deep-focus earthquakes as deep as 520 kilometres (320 mi) below the surface.[15] however, very few earthquakes occur in the region less than 100 kilometres (62 mi) deep, the majority originating from a depth of around 250–300 kilometres (160–190 mi). Due to the lack of shallow earthquakes, the faulting is believed to originate from an ancient subduction zone that began subducting less than 15 million years ago, and largely finished around 10 million years ago, no longer visible on the surface.[16] Due to the calculated subduction rate, the cause for subduction was likely to be internal stressing on the Eurasian Plate, rather than due to the collision of the African and Eurasian Plates, the cause of modern-day subduction for the nearby Aegean Sea and Anatolian microplates.

Afghanistan [ edit ]

In northeastern Afghanistan, a number of medium-intensity deep focus earthquakes of depths of up to 400 kilometres (250 mi) occasionally occur.[17] They are caused by the collision and subduction of the Indian Plate under the Eurasian Plate, the deepest earthquakes centered on the furthest subducted sections of the plate.[18]

South Sandwich Islands [ edit ]

The South Sandwich Islands between South America and Antarctica are host to a number of earthquakes of up to 320 kilometres (200 mi) in depth.[19] They are caused by the subduction of the South American Plate under the South Sandwich Plate.[20]

Notable deep-focus earthquakes [ edit ]

The strongest deep-focus earthquake in seismic record was the magnitude 8.3 Okhotsk Sea earthquake that occurred at a depth of 609 km in 2013.[21] The deepest earthquake ever recorded was a small 4.2 earthquake in Vanuatu at a depth of 735.8 km in 2004.[22] However, although unconfirmed, an aftershock of the 2015 Ogasawara earthquake was found to have occurred at a depth of 751 km.[23]

en.wikipedia.org - Deep-focus earthquake - Wikipedia

Why doesn t California use ocean water?

Desalinated water is currently more expensive than other sources, and the area has a local groundwater basin that meets 75% of its water demand and...

Last updated Jun 19, 2019